top of page

So, you've bought a custom marquee frame and you're trying to figure out how to get your marquee in there, huh?  No worries, just follow these easy steps:

Rear Panel

Rear Panel

Remove the four screws that hold the rear panel in place.

Panel Removed

Panel Removed

Pull the rear panel/light assembly out of the recessed area of the frame.

End Cap Attachment Screws

End Cap Attachment Screws

Remove the two screws that hold on one of the end caps.

End Cap Removed

End Cap Removed

Here you can see the channels that the marquee will slide into on the frame>

Marquee Install

Marquee Install

Slide the marquee into the frame - make sure it's not upside down!

Almost There!

Almost There!

Slide the marquee all the way into the frame until it touches the opposite end cap.

Back Together

Back Together

Now you can start reassembling the light box.

Replace Screws

Replace Screws

Replace the two screws that hold the end cap on - be careful to not over tighten them.

Panel Replacement

Panel Replacement

Replace the rear panel/light fixture and snug the four screws.

Lights!

Lights!

Done! Enjoy your marquee.

bottom of page